Winsafe Modular Outrigger Beams

When looking to rent or buy Modular Outrigger Beams, the best name in the business is Winsafe. Swing Staging is proud to rent and install these beams from the Winsafe Corporation.

When you are considering modular outrigger beam platform for your project or jobsite, consider the benefits of Winsafe’s outrigger beams.

Brochure

Brochure 2

Brochure 3

Manual Modular Beams

Manual 1500 Beam Series

Manual 18’ or 20’ Cable Truss System

Manual 13.5’ Reach Winsafe Outrigger

Read More

Full Description

Winsafe

When looking to rent or buy Modular Outrigger Beams, the best name in the business is Winsafe. Swing Staging is proud to rent and install these beams from the Winsafe Corporation.

When you are considering modular outrigger beam platform for your project or jobsite, consider the benefits of Winsafe’s outrigger beams.

Winsafe’s Modular Outrigger Benefits:

  • Facilitate every job up to 14 feet, and work on overhangs.
  • Simplifies field work with easy to carry and pin together on site, light eight foot lengths.
  • Tubular beam is safer, more resistant to lateral deflection and twist than comparable I sections.
  • About the same cost as make it yourself aluminum beams but with greater tensile strength.
  • The outrigger beams provide up to a 4 ft. reach. The 16 ft. system has an 8 ft. front beam, standard splice and 8 ft. rear beam with a slot for cast weights.

Overhang beams facilitate workers to reach areas directly below an overhang or cornice. The fully adjustable components enable a reach up to 5 ft. down and 4 ft. under an overhang.

The cable truss system provides up to an 8 ft. reach at 1,000 lbs. capacity. As with the straight beams, the cable truss upright and the wire ropes pin to the beams. For the setup shown below, a front beam, cable truss, two mid sections, a rear section and two splices have been used. After the beam has been put in position, the optional sliding beam collar allows suspension point adjustment.

Strong and Versatile Modular Outrigger Beams

The Standard Internal Splice joins the sections together quickly and easily with connector pins – no splice plates – no nuts and bolts – no wrenches. Each front, band and mid-beam section weighs only 32 lbs. This makes the beam components easy to carry and easy to handle in building corridors and elevators.

A Drop Forged Link is hooked to the suspension cables. This provides two advantages:

  1. The link moves out of the way for easy handling when transporting or storing the beams and it is very strong.
  2. The link has a working strength of 4,200 lbs. and an ultimate strength of 25,200 lbs.

Workers can also adjust the position of the suspension point without moving the beam. When working on confined rooftops the optional sliding collar provides the flexibility of moving the suspension point.

Both Longhorn weights and Cast weights can be used with this system. For longhorn weights there is a 30 in. and 42 in. longhorn available. For cast weights there is a machined slot that will accept 7 weights and there is a beam saddle available that will take an additional 12 cast weights. If the desired weight system doesn’t fall into these two categories, Winsafe can build a custom weight holder system as required.


FOR ALL YOUR SCAFFOLDING NEEDS!
Swing Staging, we are the largest suspended scaffolding rental company in NYC and in the East Coast.

We rent all types of scaffolding equipment including pipe scaffolding, mastclimbers, sidewalk bridge components.

If you have questions regarding the rental and installation of modular outrigger beams, please give us a call at (718) 361-2861. For more information, please click here.